Kubota RTV 500 Transmission Problems And Their Solutions

If you’re looking for Kubota RTV 500 Transmission Problems and their solutions, you’ve come to the right place. Our team has confirmed this information with several Kubota representatives and associates.

Let’s talk about the Kubota RTV 500 Transmission Problems and their solutions. Finding complete information on the internet can be challenging.

Therefore, we prefer that you save your precious energy and time. Our team has compiled complete information on Kubota RTV 500 Transmission Problems to make your search easier.

So, without further ado, let’s get to the main topic.

Kubota RTV 500 Transmission Problems

Kubota RTV 500 Transmission Problems And Their Solutions

Here is a list of Kubota RTV 500 Transmission Problems and how to fix them. Which are as follows.

➡ (1) Cold hydraulic system malfunction

➡ (2) Hydrostatic Transmission pump failure

➡ (3) Hydraulic system overheating

➡ (4) Transmission overheating

➡ (5) Transmission slippage

(1) problem 1: Cold hydraulic system malfunction

If the transmission on your Kubota RTV 500 is too cold, it can cause severe damage to your system. Initially, the hydraulic fluid thickens and stops getting to the pump. Over time, the hydraulic system won’t be able to get rid of the heat, which will hurt the transmission.

Solutions

To keep your transmission fluid from getting too thick, you would need to add an anticoagulant. Also, if the temperature probe keeps telling you that the car is too cold, you should take it to a mechanic.

What signs are shown by this Kubota RTV 500 transmission problem?

If one hydraulic system is too cold to collaborate and needs to be warmed up, you will see a sign on the dashboard.

(2) problem 2: Hydrostatic Transmission pump failure

Most of the time, the Kubota RTV 500 Transmission Fuel Pump delivers well, but sometimes it stops working very early on, and as it gets older, it gets harder and harder to make pressure. This will primarily affect how well the vehicle can shift.

Solutions

Most of the time, this is because the transmission oil pump is chosen to wear out now and must be replaced. In other cases, this problem has been fixed by separating the oil pump and putting it back together.

What signs are shown by this Kubota RTV 500 transmission problem?

When you’re driving, you’ll notice that shifting is problematic or, in the worst case, doesn’t work at all. Since this is a changing problem, you will only notice it when driving at the given speed and rpm.

(3) problem 3: Hydraulic system overheating

When the fluid gets into the transmission of a Kubota RTV 500, it can cause temperature problems and lead the system to overheat. This is another common problem with the Kubota RTV 500 transmission, caused by leaks in the scheme that gets fluids dirty.

Solutions

The two gears’ solenoids may be made to wear out and should be replaced. Also, these solenoids may be broken as well. These transmissions rarely fail because of mechanical problems.

What signs are shown by this Kubota RTV 500 transmission problem?

An error message usually pops up whenever a Kubota RTV 500 transmission gets too hot. This error doesn’t show up right away on the screen. It would help if you had a diagnostic to determine the actual error codes.

(4) problem 4: Transmission overheating

The transmissions in Kubota RTV 500s seem to be very advanced and can’t leak. If something starts to leak out of them, it could cause the transmission to overheat. It clearly indicates an issue that could cause you a lot of trouble in the future.

Solutions

The most obvious way to correct this sign before it hurts your car’s mechanical parts is to find where the release is and seal it. Fluid leaks usually happen because the gaskets or sealants inside the transmission are chosen to wear out or break.

What signs are shown by this Kubota RTV 500 transmission problem?

You would get a mistake like P0842 or one in the same range that has to do with the pressure of the transmission fluid. If these sensors show low pressure, there isn’t enough fluid in the transmission, and it’s leaking somewhere.

(5) problem 5: Transmission slippage

The transmission system on a Kubota RTV 500 isn’t meant to slip, and if it does, it could make the vehicle move more slowly or cause more damage to the transmission system. So, this is a sure sign that something is wrong with the transmission’s hydrostatic parts.

Solutions

The two gears’ solenoids may be made to wear out and should be replaced. Also, these solenoids may be broken as well. These transmissions rarely fail because of mechanical problems.

What signs are shown by this Kubota RTV 500 transmission problem?

You will understand the transmission slip when you are driving, which is a good sign that it is slipping. Also, when you use a diagnostic, it will show you an error code.

Kubota RTV 500 Transmission Problems FAQs

(1) How many hours can you get out of a Kubota RTV?

If you keep your Kubota tractor in good shape, it should last somewhere around 4500 and 5500 gauged hours. Since many tractor owners say they only use theirs for 100–200 hours per year, this can add to years of use. If you take good care of a Kubota tractor and possess the time and skills to do so, it might last longer than 10,000 hours.

(2) How to prevent getting these problems in the first place?

Taking care of your transmission regularly is a simple way to make it last longer. If you don’t get your transmission repaired on time, the internal parts, like the hydraulic system, which is the heart of a hydrostatic transmission, will wear out badly.

(3) How does a Kubota RTV transmission work?

People call the Kubota transmission a “Variable Hydro.” It means it works more like a tractor transmission than just a UTV transmission. The engine’s RPMs go up when you push the accelerator, but it’s not quite the same as a standard CVT transmission.

(4) How to diagnose these common problems with Kubota RTV 500 transmission precisely?

If you have driven before and know what to do, you can immediately use commonly used diagnostic tools like OBD-II to fix these problems.

For some people, the only way to know what these signs mean is to go to a local machinist or service station, where they will have a much more accurate examination method.

Final Words

➡ In this short guide, we’ve told you about the most common transmission problems with the Kubota RTV 500 and how to fix them.

➡ We hope you liked this article. If you like this article then please share this article with your family and friends. You can do so in the comments section if you want to tell us more about your situation.

This article I have created this to give you complete information about the Kubota RTV 500 Transmission Problems.

Check out the given details which help you to know about the Kubota RTV 500 Transmission Problems.

For more information visit our website: Commercialvehicleinfo.com